egg tree 3d display stand
by Snapdragon Snippets
Design ID #187900
Requires 12x12 cutting capacity. Sturdy riser with contour base has two-part card stock pole "wrap" that holds a 3/4" diameter wood dowel cut to length. Cross-arms are layered for strength, with notches to hold twine loops for a dozen decorated egg ornaments. Attach arm units on pole front at top edge, where pole dash markings indicate, then wrap long brackets around pole, glue tab ends to arm backside. Optional front short bracket completes the bracket look. Complete stand top accent with optional flower finial that takes the place of regular long bracket. Arm end punch holes can be covered with decorative studs or brads. Measures approx. 16.5" tall x 12" wide x 4.25
" deep (base) . View assembly …(Click here for more)
This design is available for personal use only.